Functions
Installation of
Siljan PolySave
gives the following advantages:
- Decreased cost due to a lowered polymer consumption. In particular, this is valid when the following factors vary:
- The DS content of incoming sludge
- The composition of the sludge
- The temperature of the sludge
- The efficiency of the polymer blending
- The aimed interval of the DS content of the thickened sludge can more easily be reached or, as an alternative, a higher DS content can be rached. The thickening process is continuously corrected for variations as per above.
- The thickening process is closed down when the DS content of incoming sludge is less than say 0.5%; This saves polymer, electricity and water. The process is started again, when the DS content of the sludge has increased.
- Minimizes the need for operators attention.
- Makes unmanned 24 hour/day thickening more efficient and reliable.
- Can be connected to the control room via a modem.
Siljan Allards AB, Phone +46(0)248-125
35
Fax +46(0)248-137 85 |
|
E-mail info@siljanallards.com
www.siljanallards.com |
|
Indirect measurement of the DS-content of incoming sludge; Closes down the sludge and polymer pumps, the flocculation reactor and the sludge thickener if the DS-content of the incoming sludge is too low;
Starts up the thickening process when the DS-content is higher.
Indirect control of the DS-content of utgoing sludge.
Direct control of the speed of the polymer pump.
Direct measurement of the suspended solids (SS) content in the filtrate water, from the drum thickener.